Photocopier n Darkroom

Using the photocopier to create interesting outcomes



Approaching this task I had a clear idea on how to represent different types of imagery and ideas I wanted to experiment with. 



Initially I knew I wanted to experiment with acetate in new/similar ways to how I have previously experimented with it. I wanted to use burning and the heat gun on acetate to see how I could manipulate the printed image that I had scanned. I had hoped that with the added heat I could physically manipulate and pull the acetate to potentially bend it like I could manipulate a photocopy whilst it was scanning, however after attempting this it seemed that the acetate would cool down very quickly and therefore I could not alter it in the way I had initially wanted. I however decided to use the heat gun to change the image and acetate in a way that gave it a 3Dimensional texture whilst retaining the same imagery as the original scan.


I wanted to experiment with altering the scan as it was happening and seeing how that would appear on acetate and so I created this wave effect for the gameboy scan which I find looks similar to a sine wave. This thought prompted the idea that I could try and use my knowledge of music in my work.


  
I decided to take an illustration I did a while ago as a vent illustration of my stress and print it onto acetate to use in the dark room process and for future experiments.

  

I took these initial images to potentially use and scan and manipulate in the future, I could likely use these in a collage and further photocopy/use more mediums such as paint or pen over them.


/Dark room\

Using the darkroom is a relatively straightforward process. The process of creating a negative requires light sensitive paper. When you expose the paper to light it absorbs that light and creates a temporary print of anything on top of the paper which allows you to create interesting patterns and imagery depending on the medium you use. I have used this technique before so I decided to do a small demo on how to do it. 
To start I prepared the acetate I was going to use and put the light sensitive paper near the light source, which was off whilst preparing (you use a red light in a darkroom because I has no effect on the light sensitive paper). once I was ready to create the temporary print, I exposed the paper to light for 2 seconds, then carried it over to the developer tray which I let sit whilst rocking gently until the image slowly appeared for 1-2 minutes. Once the negative was as developed as preferred, I placed it in the stop tray for around 10 seconds - this effectively stops the developer from developing the negative. After 10 seconds I gently rocked it in the fixing tray for 1-2 minutes, which fixed the print in place. Then I carefully hung it up to dry before moving onto the next negative.

  

  




Comments

Popular Posts